| Classic Mini Blinds
3
TO INSTALL CENTER SUPPORT BRACKET(S):
Proceed to “Blind Installation”.
TO INSTALL THE END MOUNTING BRACKETS:
OUTSIDE MOUNT
• Unwrap the cellophane from around the blind stack.
Caution: DO NOT cut the cellophane as the cords or ladders
supporting the blind may be inadvertently cut.
• Lower the blind to its full length. (See “Blind Operation”)
• Hold the blind up to the
desired mounting position.
• Once the blind is level,
mark the wall at the lower
corners of each end of the
headrail using a pencil
• Draw the blind completely
up and set it aside.
• Using a flathead
screwdriver, open the
latches of the end
brackets.
• Facing the window,
position the end bracket
marked “LH” above the
top left corner of the
window,
1
/
8
" TO THE LEFT
of the pencil marks.
• Using a pencil, mark the
wall through the holes
in the back of the end
bracket. For maximum
stability, the pencil
marks should be made
diagonally.
• Using a drill with a
1
/
16
" drill
bit or an awl, make a small
pilot hole at each pencil
mark.
• Mount the bracket
using two of the screws
provided.
• Repeat this procedure
for the right end bracket,
making sure the end
bracket marked “RH” is
positioned above the
top right corner of the
window,
1
/
8
” TO THE
RIGHT of the pencil marks.
• If your hardware packet
includes one center
support bracket, position
it as close to the center
of the mounting surface
as possible, making
sure it will not interfere
with any moving parts.
If more than one center
support bracket has been
provided, position them
equidistant from the end
brackets and each other,
again avoiding all moving
parts.
• Make sure all center
support brackets are
positioned at the same
height and are level with
the end brackets.
• Using a pencil, mark the
mounting surface through
the holes in the back
of the center support
bracket. For maximum
stability, the pencil marks
should be made in the top
two holes of the center
support bracket.
• Using a drill with a 1/16”
drill bit or an awl, make
a small pilot hole at each
pencil mark.
• Mount the bracket
using two of the screws
provided.
• Repeat this procedure
for any remaining center
support bracket(s).
1
/
8
"
