Assembly Instructions Beta Prusa Standard & Deluxe
01/07/14
NOTICE
Make sure to cut the thick cable for the heated print bed to exactly 50 cm
length.
Securing of the through hole connections
Secure the through hole connections on the sides of the heated print bed with Kapton tape to
protect against possible shorts with the aluminium plate.
After taping the print bed, you should pierce through the holes so its possible to put a screw
into it later.
Secure the cables on the heated printbed with kapton tape to make sure they can't bend and
fall off.
Assembly step 4.4
Mount the heated print bed onto the y carriage with four M3 x 30 mm screw, the spring which
was cut into 4 parts, washers and nuts as shown in the picture above. The M3 Nyloc nut
Page 47/ 67
