For product 2N StarGate you need 3 IP addresses. 1x- basic CPU, 1x – enhanced CPU
(eCPU), 1x VoIP card.
Settings of IP´s
As first step it is recommended to set up IP address of basic CPU. You need to connect
your notebook via serial cable RS-232 to the CPU board. In case you don´t have serial
(COM) port on your laptop, use convertor RS-232 to USB. Install drivers of this convertor
and check number of COM port you are connected to.
After you finished first step, install PRI program which you can find on CD delivered
with your device. Open PRI program and go to the menu
Settings -> Communication
settings... There you need to choose Serial cable and number of used COM port to which
the gateway is connected to. Then go to the menu “gateway” -> “connect gateway” (you
can use quick-button icon as well). Window “Would you like to load parameters from the
gateway 2N StarGate?”, will appear and you just press “Yes”. Now you are connected to
the gateway.
On the left side you can see main navigation panel. Go to the”Gateway configuration” -
> “System parameters”. There you will be able to set IP address, subnet mask and IP of
