2N SingleTalk, User Manual

Page: 56 / 73

Review of Programming Functions 3.2
55
Function
Number and Name Value Range Initializa-
tion Value Notes, Explanations
962 – minimum button pressing
time
01–99
1 = 0.1 s
change
Applies to all buttons.
963 – hang-up option with the
same button
0 – disabled
1 – enabled
0
The calling party may not terminate the call
according to applicable regulations.
964 – option to dial another
number by pressing
another button
0 – disabled
1 – enabled
1
Correction of an implicit value in the table. Since
the other buttons are not practically used, the
parameter value is of minimum significance.
971 – count of message
repetitions
0–9 3
There is a 3-second pause between two
subsequent messages.
972 – record a message (Only if
a voice recording module
is available. Otherwise,
the “Wait please,
connection is being
made“ message is played
back.) Enter the
service
password,
record 0 – 30
seconds
„Wait
please,
connection
is being
made“
Recording is password protected (to start enter *
service password * ). Start after the long tone
end. To terminate recording, press any DTMF
key on the phone. After recording is completed,
the
ST hangs up.
974 – Lift identification 16 digits –
A new, digital parameter to facilitate lift
identification to foreigners, e.g.
It can be transmitted by DTMF for automated
detection (LiftManager)
975 – Message options 2 digits 55
1st digit = type of message repeated after
dialing. 2nd digit = message type after
confirmation.
Both digits has these options:
1 = user recrded message
2 = identification (974) spelled
3 = combination of options 1+2
4 = identification (974) by DTMF
5 = message selected by par. 977
(after confirmation par. 976)
6 = combination of options 5+2
7 = confirming tone (after confirmation only)
976 – Call end message
language selection
0–9 1
0 =
1 = English 2 - 3 =
4 = German 5 - 7 = 8 = Portuguese
9 = Dutch 10 ... 99 = silence
Note: see Survey of messages in chapter 4.2
977 – Outgoing call message
selection
0–9 1