2N® LiftIP 2.0 User Manual
11
/
119
•
•
•
•
•
•
•
•
2. Description and Installation
This section describes the
2N
®
LiftIP 2.0
product and its installation.
Here is what you can find in this section:
2.1 Product Description
2.2 Before You Start
2.3 Mounting
2.4 Connection
2.5 Description of Terminals, Jumpers, Connectors and LEDs
2.6 Button Functions
2.7 2N® Voice Alarm Station
2.8 2N® LiftIP 2.0 Relay Extender
2.1 Product Description
2N
®
LiftIP 2.0
is an alarm lift communicator providing full-duplex audio transmission via the
VoIP technology directly from the lift cabin. A microphone and a speaker are built-in behind the
lift panel for bidirectional communication. It includes external power supply terminals, an
ALARM button,
illuminated pictograms (device states as standardized) and a CANCEL input
(optional cabin door opening signal).
Device Operation
Press the ALARM button. The pictogram goes on instantaneously.
Wait
, the pictogram goes on
after communication is established:
Connection established
.
Universal Design
The electronics board is located between the mounting panel and the instruction printed cover
(see the Fig.). The overall dimensions are 65 (W) x 130 (H) x 24 (D) mm. The speaker, microphone
and 2 LEDs (green, yellow) are connected on the motherboard (according to the Part No.).
Jumpers (included in the product accessories) are mounted to the left. The small bottom
connectors are intended for an induction loop connection (for hearing-impaired people).
Typically, illuminated pictograms (also bulbs) are connected to this product. The pictograms
and the ALARM button are not part of the delivery (they are design lift elements).
