2N 2Wire, How To Use, Page: 2 / 4

Product use

Install 2N® 2Wire master unit where your Ethernet cable ends and 2-cable wiring begins.

Plug in Ethernet and 2 cable wiring into the master unit.

Install 2N® 2Wire slave unit where you need convert 2-cable wiring back to Ethernet at remote
location. Please observe polarity of the 2 wires.

Connect provided power supply to master unit.

Any of the units can be master or slave. Master unit is the one with connected power supply
while slave is powered via 2 wires.

Blue Power LED indicators should indicate that both units are powered.

Both BNC and PoE green LED should be blinking, thus signalling the established connection and
data transmission.
Specification

Speed : 10/100 Base T, half/full duplex, auto-negotiation

IEEE 802.3 af/at 40Watt Compliant PoE+

Cable Type : 2Wire, Cat 5e., Cat 6. or Similar

Impedance : 25Ω to 100Ω

Transmit Coverage : Typical 720ft (220m) @ Cat6 with PoE at far end; up to 2460ft (750m)
possible; depends on wiring and interference
LED Indicators

Power : Blue
– Power ON

BNC : Green
– Link ON

PoE : Green
– Link ON