7
www.2MTechnology.net
6.
Insert M8X80 expansion bolts into the three fixing holes on the ground, and
make sure that the expansion bolts are a bit higher than the ground.
M8x80 expansion
bolts
7.
Erect the standing pole, align the hole position at pole bottom with the
expansion bolts fixed on the ground, adjust the standing pole so that it’s
perpendicular to the ground, adjust device direction, and then fasten the
standing pole with nuts.
8.
Lead the tail cable out through the hole on the round base plate.
9.
Refer to the figure below to fasten the base plate with screws.
Ground
Summary of Contents for 2MITD-2
Page 4: ...2 www 2MTechnology net...
Page 23: ......
