2E C3220B, User Manual, Page: 4 / 35

– 4 –
EN
４ ５
４ ５
Operating Instructions
Components and auxiliary equipment
Before assembling and installing, check for following items to be included in this display package.
Monitor
Power cord
Stand base
HDMI cable
Microfiche and power
requirements label
User manual
４ ５
PSU
the points of connection to the plug, sockets and the power cord to the appliance.
10. Unplug the appliance during a lightning storm or when it is not used for a long period of time.
11. Unplug this product when the device, power cord or plug are damaged or if the device has been
exposed to liquid or moisture, has been mechanically damaged and does not work properly and
contact an authorized service centre immediately.
12. Keep this appliance away from liquids, splashes of water and do not place objects filled with liquids
on it.
13. Do not disassemble the back cover as it contains high voltages inside and will cause electric shock.
There is no spare parts inside. Internal adjustments and checks should only be conducted by
qualified professionals.
14. Do not place naked flame sources, such as lit candles on or near the monitor. Please pull out the
power plug and contact after sales support if there are abnormal objects or water in the monitor.
Instruction of Base Installation
1.
Remove the small cover on the rear shell, as shown in Fig. 1
2. Install the base support at the position shown in Fig. 2
3. Fix the base support on the machine with four Ø4x9 screws, as shown in Fig. 3
4. Install the small cover on the whole machine through the support, as shown in Fig. 4
5. Install the base on the support, and fix the base on the support with M6x14mm combination screw
with shrapnel, as shown in Fig. 5 and Fig. 6
Fig. 1 Fig. 2
Ø4x9 screws
Fig. 3 Fig. 4
M6x14mm combination screws
Fig. 5 Fig. 6
Note: Some of the contents in this manual may differ slightly from the final product, and the later shall be
referred to.