2connect Aerpro APVFT12, Manual

Page: 5 / 8

5
INSTALLATION
1. Connect the female 8pin Molex connector of the harnessto the male 8pin
Molex connector of the interface.
2. Transfer the female 52pin connector of the vehicle harness from the rear of
the head-unit into the male 52pin connector of the harness.
3. Plug the female 52pin connector of the harness into the male 52pin
connector on the rear of the head-unit.
Connection to the Rear-View Camera
Connect the video RCA of the rear-view camera to the female RCA connector
of the supplied harness.
Connect the white cable of the supplied harnessto the camera power supply
(+12V max 500mA). The white cable receives power when reverse gear is
e n g a g e d .
Rear-View Camera Coding
1. Set DIP switch “2” to “OFF” position
2. Turn on ignition
3. Wait until the head-unit hasbooted up
4. Set DIP switch “2” to “ON” position
5. Reset the system to complete the coding operation
Supplied Harness
www.aerpro.com.au