ZyXEL Communications ZyWall, Справочное руководство

Страница: 78 / 394

Chapter 6 Interfaces
ZyWALL (ZLD) CLI Reference Guide
78
6.8.2.1 WLAN Interface Commands Example
This example configures WLAN AP interface 2 for slot 1 to use SSID WLAN_test, WPA
security modes with a pre-shared key of 12345678, IP address 1.1.1.1, netmask 255.255.255.0,
and a gateway IP address of 1.2.3.4 with a priority of 10.
[no] security dot1x acct ip port
<1..65535>
Sets the IP address and port number of an external
accounting server.
[no] security dot1x auth ip port
<1..65535>
Sets the IP address and port number of an external
authentication (RADIUS) server.
[no] security dot1x activate
Enables IEEE 802.1x accounting and authentication.
[no] security external acct ip port
<1..65535>
Sets the IP address and port number of an external
accounting server.
[no] security external auth ip port
<1..65535>
Sets the IP address and port number of an external
authentication (RADIUS) server.
no security {none | wep | wpa |
wpa-wpa2 | wpa2}
Disables the specified security mode for the wireless
interface.
ssid ssid
Sets the (Service Set IDentity). This identifies the Service Set
with which a wireless station is associated. Wireless stations
associating to the ZyWALL must have the same SSID.
ssid
: Use up to 32 printable 7-bit ASCII characters as a
name for the wireless LAN.
station-limit <1..255>
Sets the highest number of wireless clients that are allowed to
connect to the wireless interface at the same time.
wep-key <1..4> key
There are four data encryption keys to secure your data from
eavesdropping by unauthorized wireless users. The values
for the keys must be set up exactly the same on the access
points as they are on the wireless stations.
If you set WEP encryption to use a 64 bit key using the
security mode
and
security wep 64
commands, type
any 5 characters (ASCII string) or 5 pairs of hexadecimal
characters ("0-9", "A-F") preceded by 0x for each key.
If you set WEP encryption to use a 128 bit key using the
security mode
and
security wep 128
commands, type
13 characters (ASCII string) or 13 pairs of hexadecimal
characters ("0-9", "A-F") preceded by 0x for each key.
Table 32 WLAN Interface Commands (continued)
COMMAND DESCRIPTION
Router(config)# interface wlan-1-2
Router(config-if-wlan)# ssid WLAN_test
Router(config-if-wlan)# security wpa tkip psk key 12345678
Router(config-if-wlan)# security mode wpa
Router(config-if-wlan)# ip address 1.1.1.1 255.255.255.0
Router(config-if-wlan)# ip gateway 1.2.3.4 metric 10
Router(config-if-wlan)# exit