ZyXEL Communications ZyWALL USG Series, Справочное руководство

Страница: 65 / 426

Chapter 7 Wireless LAN Profiles
ZyWALL / USG (ZLD) CLI Reference Guide
65
7.5 Security Profile Commands
The following table identifies the values required for many of these commands. Other input values
are discussed with the corresponding commands.
The following table describes the commands available for security profile management. You must
use the
configure terminal
command to enter the configuration mode before you can use
these commands.
Table 17
Input Values for General Security Profile Commands
LABEL DESCRIPTION
security_profile_name
The security profile name. You may use 1-31 alphanumeric characters,
underscores (
_
), or dashes (-), but the first character cannot be a number. This
value is case-sensitive.
wep_key
Sets the WEP key encryption strength. Select either
64bit
or
128bit
.
wpa_key
Sets the WPA/WPA2 pre-shared key in ASCII. You may use 8~63 alphanumeric
characters. This value is case-sensitive.
wpa_key_64
Sets the WPA/WPA2 pre-shared key in HEX. You muse use 64 alphanumeric
characters.
secret
Sets the shared secret used by your network’s RADIUS server.
auth_method
The authentication method used by the security profile.
Table 18
Command Summary: Security Profile
COMMAND DESCRIPTION
show wlan-security-profile {all |
security_profile_name }
Displays the security profile(s).
all
: Displays all profiles for the selected operating mode.
security_profile_name
: Displays the specified profile for the
selected operating mode.
wlan-security-profile rename
security_profile_name1 security_profile_name2
Gives existing security profile (
security_profile_name1
) a new
name, (
security_profile_name2
).
[no] wlan-security-profile
security_profile_name
Enters configuration mode for the specified security profile. Use
the
no
parameter to remove the specified profile.
mode {none | wep | wpa | wpa2 | wpa2-mix}
Sets the security mode for this profile.
wep <64 | 128> default-key <1..4>
Sets the WEP encryption strength (
64 or 128
) and the default
key value (
1 ~ 4
).
If you select WEP-64 enter 10 hexadecimal digits in the range of
“A-F”, “a-f” and “0-9” (for example, 0x11AA22BB33) for each Key
used; or enter 5 ASCII characters (case sensitive) ranging from
“a-z”, “A-Z” and “0-9” (for example, MyKey) for each Key used.
If you select WEP-128 enter 26 hexadecimal digits in the range of
“A-F”, “a-f” and “0-9” (for example,
0x00112233445566778899AABBCC) for each Key used; or enter
13 ASCII characters (case sensitive) ranging from “a-z”, “A-Z”
and “0-9” (for example, MyKey12345678) for each Key used.
You can save up to four different keys. Enter the
default-key
(
1
~ 4
) to save your WEP to one of those four available slots.
wep-auth-type {open | share}
Sets the authentication key type to either
open
or
share
.