ZyXEL Communications XS3800-28, Руководство пользователя, Страница: 671 / 789

Chapter 87 MAINTENANCE
XS3800-28 User’s Guide
671
Figure 531 MAINTENANCE > Cluster Management > Cluster Management Setup > Add/Edit
The following table describes the labels in this screen.
87.7 Technical Reference
This section provides technical background information on the topics discussed in this chapter.
87.7.1 Cluster Member Switch Management
Go to the MAINTENANCE > Clustering Management > Clustering Management Status screen of the
cluster manager switch and then select an Index hyperlink from the list of members to go to that cluster
member switch's Web Configurator home page. This cluster member Web Configurator home page
and the home page that you would see if you accessed it directly are different.
Table 362 MAINTENANCE > Cluster Management > Cluster Management Setup > Add/Edit
LABEL DESCRIPTION
List A list of suitable candidates found by auto-discovery is shown here. The switches must be
directly connected. Directly connected switches that are set to be cluster managers will not
be visible in the
Clustering Candidate list. Switches that are not in the same management
VLAN group will not be visible in the Clustering Candidate list.
Password Each cluster member’s password is its Web Configurator password. Select a member in the
Clustering Candidate list and then enter its Web Configurator password. If that switch
administrator changes the Web Configurator password afterwards, then it cannot be
managed from the
Cluster Manager . Its Status is displayed as Error in the Cluster
Management Status screen.
If multiple devices have the same password then hold [SHIFT] and click those switches to
select them. Then enter their common Web Configurator password.
You can enter up to 32 printable ASCII characters except [ ? ], [ | ], [ ' ], [ " ] or [ , ].
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to reset the fields to the factory defaults.
Cancel Click Cancel to begin configuring this screen afresh.