ZyXEL Communications XS3800-28, Руководство пользователя, Страница: 526 / 789

Chapter 71 Static Route
XS3800-28 User’s Guide
526
C
HAPTER
71
Static Route
71.1 Static Routing Overview
This chapter shows you how to configure static routes.
The Switch uses IP for communication with management computers, for example using HTTP, Telnet, SSH,
or SNMP. Use IP static routes to have the Switch respond to remote management stations that are not
reachable through the default gateway. The Switch can also use static routes to send data to a server
or device that is not reachable through the default gateway, for example when sending SNMP traps or
using ping to test IP connectivity.
The Switch usually uses the default gateway to route outbound traffic from computers on the LAN to the
Internet. To have the Switch send data to devices not reachable through the default gateway, use
static routes.
For example, the next figure shows a computer ( A ) connected to the Switch. The Switch routes most
traffic from A to the Internet through the Switch’s default gateway ( R1 ). You create one static route to
connect to services offered by your ISP behind router R2 . You create another static route to
communicate with a separate network behind a router R3 connected to the Switch.
Figure 415 Example of Static Routing Topology
71.1.1 What You Can Do
• Use the IPv4 Static Route screen ( Section 71.2 on page 527 ) to configure and enable an IPv4 static
route.
• Use the IPv6 Static Route screen ( Section 71.3 on page 528 ) to configure and enable an IPv6 static
route.
N1