ZyXEL Communications XS3800-28, Руководство пользователя, Страница: 48 / 789

Chapter 3 Hardware Panels
XS3800-28 User’s Guide
48
Figure 15 Connecting the Fiber Optic Cables
3.1.2.2 Transceiver Removal
Use the following steps to remove an SFP transceiver.
1
Attach an ESD preventive wrist strap to your wrist and to a bare metal surface on the chassis.
2
Remove the fiber optic cables from the transceiver.
3
Pull out the latch and down to unlock the transceiver (latch styles vary).
Note: Make sure the transceiver’s latch is pushed all the way down, so the transceiver can be
pulled out successfully.
4
Pull the latch, or use your thumb and index fi nger to grasp the tabs on both sides of the transceiver, and
carefully slide it out of the slot.
Note: Do NOT pull the transceiver out by force. You could damage it. If the transceiver will not
slide out, grasp the tabs on both sides of the transceiver with a slight up or down motion
and carefully slide it out of the slot. If unsuccessful, contact Zyxel Support to prevent
damage to your Switch and transceiver.
5
Insert the dust plug into the ports on the transceiver and the cables.
Figure 16 Removing the Fiber Optic Cables
Figure 17 Opening the Transceiver’s Latch Example
Figure 18 Transceiver Removal Example