ZyXEL Communications XS3800-28, Руководство пользователя, Страница: 325 / 789

Chapter 44 Multicast
XS3800-28 User’s Guide
325
The following table describes the fields in the above screen.
44.11 MLD Snooping-proxy Filtering Profile
Use this screen to view and create MLD filtering profiles.
Click SWITCHING > Multicast > IPv6 Multicast > Filtering Profile to display the screen as shown.
Figure 237 SWITCHING > Multicast > IPv6 Multicast > Filtering Profile
Table 145 SWITCHING > Multicast > IPv6 Multicast > Filtering
LABEL DESCRIPTION
MLD Snooping-proxy Filtering
Active Enable the switch button to enable MLD filtering on the Switch.
SLOT This field appears only in Stacking mode. Click the drop-down list to choose the slot number
of the Switch in a stack.
Port This field displays the port number. In Stacking mode, the first number represents the slot ID
and the second is the port number. Please note that the default stacking ports (the last four
ports of your Switch) cannot be configured. They are reserved for stacking only.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to
set the common settings and then make adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
Group Limit Select this option to limit the number of multicast groups this port is allowed to join.
Max Group Number Enter the number of multicast groups this port is allowed to join. Once a port is registered in
the specified number of multicast groups, any new MLD Report message is dropped on this
port.
MLD Snooping-proxy
Filtering Profile Select the name of the MLD filtering profile to use for this port. Otherwise, select Default to
prohibit the port from joining any multicast group.
You can create MLD filtering profiles in the SWITCHING > Multicast > IPv6 Multicast > Filtering
Profile screen.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to reset the fields to your previous configuration.