ZyXEL Communications XS3800-28, Руководство пользователя, Страница: 274 / 789

Chapter 38 ZULD
XS3800-28 User’s Guide
274
devices too. If OAM is not enabled initially, ZULD will not work.
• If OAM is enabled initially and later disabled on one end of a link, the link will be unidirectional as that
end cannot send OAMPDUs.
• OAM discovery, the sending of OAMPDUs to other ports, is initiated by an active port.
• When
ZULD detects a unidirectional link, it sends a syslog and SNMP trap and may shut down the
affected port ( Aggressive Mode ).
• If a port on the Switch is shut down by ZULD , and you want to recover it, then do one of the following:
• Go to PORT > Port Setup . Clear Active and click Apply . Then select Active and click Apply again.
• Go to SECURITY > Errdisable > Errdisable Recovery and set the interval for ZULD . After the interval
expires, the closed ports will become active and start receiving packets again.
• Use the command
port no inactive
.
• Refer to the ZULD logs to see when a unidirectional link is detected and when it is recovered to a
bidirectional link.
38.2 ZULD Status
Use this screen to see details of unidirectional and bidirectional links discovered by ZULD . To open this
screen, click PORT > ZULD > ZULD Status .
Figure 190 PORT > ZULD > ZULD Status (Standalone Mode)