ZyXEL Communications XS3800-28, Руководство пользователя, Страница: 231 / 789

Chapter 34 Link Aggregation
XS3800-28 User’s Guide
231
Figure 155 PORT > Link Aggregation > Link Aggregation Control Protocol (Stacking Mode)
The following table describes the labels in this screen.
Table 99 PORT > Link Aggregation > Link Aggregation Control Protocol
LABEL DESCRIPTION
Active Enable the switch button to enable Link Aggregation Control Protocol (LACP).
System Priority LACP system priority is a number between 1 and 65535. The switch with the lowest system priority
(and lowest port number if system priority is the same) becomes the LACP “server”. The LACP
“server” controls the operation of LACP setup. Enter a number to set the priority of an active port
using Link Aggregation Control Protocol (LACP). The smaller the number, the higher the priority
level.
Use this section to enable LACP on trunks.
Group ID The field identifies the link aggregation group, that is, one logical link containing multiple ports.
LACP Active Select this option to enable LACP for a trunk.
Use this section to configure LACP timeout on ports.