ZyXEL Communications XMG3512-B10A, Руководство пользователя

Страница: 39 / 293

Chapter 4 Tutorials
XMG3512-B10A User’s Guide
39
4.3.2 Using WPS
This section shows you how to set up a wireless network using WPS. It uses the XMG as the AP and Zyxel
NWD210N as the wireless client which connects to the notebook.
Note: The wireless client must be a WPS-aware device (for example, a WPS USB adapter or
PCMCIA card).
There are two WPS methods to set up the wireless client settings:
• Push Button Configuration (PBC) - simply press a button. This is the easier of the two methods.
• PIN Configuration - configure a Personal Identification Number (PIN) on the XMG. A wireless client
must also use the same PIN in order to download the wireless network settings from the XMG.
Push Button Configuration (PBC)
1
Make sure that your XMG is turned on and your notebook is within the cover range of the wireless signal.
2
Make sure that you have installed the wireless client driver and utility in your notebook.
3
In the wireless client utility, go to the WPS setting page. Enable WPS and press the WPS button for more
than five seconds (
Start or WPS button).
4
Push and hold the WPS button located on the XMG’s front panel for more than 5 seconds. Alternatively,
you may log into XMG’s web configurator and go to the Network Setting > Wireless > WPS screen.
Enable the WPS function for method 1 and click Apply . Then click the WPS button.
Note: Your XMG has a WPS button located on its front panel as well as a WPS button in its
configuration utility. Both buttons have exactly the same function: you can use one or
the other.
Note: It doesn’t matter which button is pressed first. You must press the second button within
two minutes of pressing the first one.
1
2
3