ZyXEL Communications XGS4600 Series, Руководство пользователя

Страница: 59 / 645

Chapter 4 Web Configurator
XGS4600 Series User’s Guide
59
8
Change a service port number but forget it.
9
You forgot to log out of the Switch from a computer before logging in again on another computer.
Note: Be careful not to lock yourself and others out of the Switch. If you do lock yourself out,
try using out-of-band management (through the management port) to configure the
Switch.
4.7 Reset the Switch
If you lock yourself (and others) from the Switch or forget the administrator password, you will need to
reload the factory-default configuration file or reset the Switch back to the factory defaults.
4.7.1 Reload the Configuration File
Uploading the factory-default configuration file replaces the current configuration file with the factory-
default configuration file. This means that you will lose all previous configurations and the speed of the
console port will be reset to the default of 115200 bps with 8 data bit, no parity, one stop bit and flow
control set to none. The password will also be reset to “1234” and the IP address to 192.168.1.1 or DHCP-
assigned IP.
To upload the configuration file, do the following:
1
Connect to the console port using a computer with terminal emulation software.
2
Disconnect and reconnect the Switch’s power to begin a session. When you reconnect the Switch’s
power, you will see the initial screen.
3
When you see the message “
Press any key to enter Debug Mode within 3 seconds ...
” press
any key to enter debug mode.
4
Type
atlc
after the “
Enter Debug Mode
” message.
5
Wait for the “
Starting XMODEM upload
” message before activating XMODEM upload on your
terminal.
6
After a configuration file upload, type
atgo
to restart the Switch.