ZyXEL Communications XGS4600 Series, Руководство пользователя

Страница: 453 / 645

Chapter 50 OSPF
XGS4600 Series User’s Guide
453
50.4 IPv4 OSPF Configuration
Use this screen to activate OSPF for IPv4 and set general settings. Click IP Application > OSPF > IPv4 OSPF
> Configuration to display the IPv4 OSPF Configuration screen. See Section 50.1 on page 448 for more
information on OSPF.
Figure 360 IP Application > IPv4 OSPF > Configuration
The follow table describes the related labels in this screen.
Table 208 IP Application > IPv4 OSPF > Configuration
LABEL DESCRIPTION
Active OSPF for IPv4 is disabled by default. Select this option to enable it.
Router ID Router ID uniquely identifies the Switch in an OSPF. Enter a unique ID (that uses the format of an
IP address in dotted decimal notation) for the Switch.
Distance Enter a number from 10 to 255 to specify the administrative distance that is assigned to routes
learned by OSPF.
The lower the administrative distance value is, the more preferable the routing protocol is.
Note: You cannot set two routing protocols to have the same administrative
distance.
Default-
information
Originate Select Active to advertise a default route in your OSPF network if there is one in the routing table.
When no matching route is found in the routing table, the default route will be used to forward
traffic.