ZyXEL Communications XGS1930-28HP, Руководство пользователя

Страница: 34 / 397

Chapter 3 Hardware Panels
XGS1930 Series User’s Guide
34
2
Remove the fiber cables from the transceiver.
3
Pull out the latch and down to unlock the transceiver (latch styles vary).
Note: Make sure the transceiver’s latch is pushed all the way down, so the transceiver can be
pulled out successfully.
4
Pull the latch, or use your thumb and index fi nger to grasp the tabs on both sides of the transceiver, and
carefully slide it out of the slot.
Note: Do NOT pull the transceiver out by force. You could damage it. If the transceiver will not
slide out, grasp the tabs on both sides of the transceiver with a slight up or down motion
and carefully slide it out of the slot. If unsuccessful, contact Zyxel Support to prevent
damage to your Switch and transceiver.
5
Insert the dust plug into the ports on the transceiver and the cables.
Figure 15 Removing the Fiber Cables
Figure 16 Opening the Transceiver’s Latch Example
Figure 17 Transceiver Removal Example
3.2 Rear Panel
The following figures show the rear panels of the Switch. The rear panels contain:
Figure 18 Rear Panel: XGS1930-28