ZyXEL Communications XGS1930-28HP, Руководство пользователя

Страница: 33 / 397

XGS1930 Series User’s Guide
33
you install or remove a transceiver.
STORAGE! All modules are dust sensitive. When not in use, always keep
the dust plug on. Avoid getting dust and other contaminant into the
optical bores, as the optics do not work correctly when obstructed with
dust.
3.1.3.1 Transceiver Installation
Use the following steps to install a transceiver.
1
Attach an ESD preventive wrist strap to your wrist and to a bare metal surface.
2
Align the transceiver in front of the slot opening.
3
Make sure the latch is in the lock position (latch styles vary), then insert the transceiver into the slot with
the exposed section of PCB board facing down.
4
Press the transceiver firmly until it clicks into place.
5
The Switch automatically detects the installed transceiver. Check the LEDs to verify that it is functioning
properly.
6
Remove the dust plugs from the transceiver and cables (dust plug styles vary).
7
Identify the signal transmission direction of the fi ber cables and the transceiver. Insert the fi ber cable into
the transceiver.
Figure 12 Latch in the Lock Position
Figure 13 Transceiver Installation Example
Figure 14 Connecting the Fiber Cables
3.1.3.2 Transceiver Removal
Use the following steps to remove an SFP transceiver.
1
Attach an ESD preventive wrist strap to your wrist and to a bare metal surface on the chassis.