Chapter 9 VLAN
XGS1930 Series User’s Guide
127
9.9 Port-Based VLAN Setup
Port-based VLANs are VLANs where the packet forwarding decision is based on the destination MAC
address and its associated port.
Port-based VLANs require allowed outgoing ports to be defined for each port. Therefore, if you wish to
allow two subscriber ports to talk to each other, for example, between conference rooms in a hotel, you
must define the egress (an egress port is an outgoing port, that is, a port through which a data packet
leaves) for both ports.
Port-based VLANs are specific only to the Switch on which they were created.
Note: When you activate port-based VLAN, the Switch uses a default VLAN ID of 1. You
cannot change it.
Note: In screens (such as
IP Setup
and
Filtering
) that require a VID, you must enter 1 as the VID.
The port-based VLAN setup screen is shown next. The
CPU
management port forms a VLAN with all
Ethernet ports.
9.9.1 Configure a Port-Based VLAN
Select
Port Based
as the VLAN Type in the
Basic Setting
>
Switch Setup
screen and then click
Advanced
Application
>
VLAN
from the navigation panel to display the next screen.
Figure 97
Advanced Application > VLAN > Port Based VLAN Setup (All Connected)
Содержание XGS1930-28HP
