ZyXEL Communications XGS-4528F, Руководство пользователя, Страница: 409 / 491

Chapter 46 Access Control
XGS-4526/4528F/4728F User’s Guide
409
46.3.5 Configuring SNMP Trap Group
From the SNMP screen, click Trap Group to view the screen as shown. Use the
Trap Group screen to specify the types of SNMP traps that should be sent to each
SNMP manager.
Figure 219 Management > Access Control > SNMP > Trap Group
The following table describes the labels in this screen.
Table 152 Management > Access Control > SNMP > Trap Group
LABEL DESCRIPTION
Trap
Destination IP Select one of your configured trap destination IP addresses. These are
the IP addresses of the SNMP managers. You must first configure a trap
destination IP address in the SNMP Setting screen.
Use the rest of the screen to select which traps the Switch sends to that
SNMP manager.
Type Select the categories of SNMP traps that the Switch is to send to the
SNMP manager.
Options Select the individual SNMP traps that the Switch is to send to the SNMP
station. See
Section 46.3.3 on page 400 for individual trap descriptions.
The traps are grouped by category. Selecting a category automatically
selects all of the category’s traps. Clear the check boxes for individual
traps that you do not want the Switch to send to the SNMP station.
Clearing a category’s check box automatically clears all of the category’s
trap check boxes (the Switch only sends traps from selected categories).
Apply Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.