ZyXEL Communications WX3310-B0, Руководство пользователя

Страница: 58 / 118

Chapter 10 Wireless LAN
WX3310-B0 User’s Guide
58
The following table describes the labels in this screen.
10.6 WPS Screen
Use this screen to enable/disable WPS, view or generate a new PIN number and check current WPS
status. To open this screen, click
Networking > Wireless Network 5G/2.4G > WPS .
Note: With WPS, wireless clients can only connect to the 5GHz or 2.4GHz wireless network using
the first SSID on the WX3310.
Figure 33 Networking > Wireless Network 5G/2.4G > WPS
Table 17 Networking > Wireless Network 5G/2.4G > Advanced
LABEL DESCRIPTION
Wireless Band Select the wireless standard you want to use for your wireless network.
Channel
Bandwidth Select the channel bandwidth you want to use for your wireless network.
Select whether the WX3310 uses a wireless channel width of 20MHz , 40MHz or 80MHz . A
standard 20MHz channel offers transfer speeds of up to 150Mbps whereas a 40MHz channel
uses two standard channels and offers speeds of up to 300 Mbps.
40 MHz (channel bonding or dual channel) bonds two adjacent radio channels to increase
throughput. A 80 MHz channel consists of two adjacent 40 MHz channels. The wireless clients
must also support 40 MHz or 80 MHz. It is often better to use the 20 MHz setting in a location
where the environment hinders the wireless signal.
Beacon Interval This is the time lag between each of the beacons sent by the wireless network.
DTIM Period The Delivery Traffic Indication Map (DTIM) period, is the moment the WX3310 will broadcast
any buffered broadcast frames, after the WX3310 broadcasts the beacon. Enter 1, and the
WX3310 will transmit broadcast frames after every beacon, enter 2 and the WX3310 will
transmit every other beacon.
Apply Click Apply to save your changes.
Cancel Click Cancel to begin configuring this screen afresh.