ZyXEL Communications WX3310-B0, Руководство пользователя

Страница: 57 / 118

Chapter 10 Wireless LAN
WX3310-B0 User’s Guide
57
10.5 Advanced Wireless Network Screen
Use this screen to select the advanced wireless settings for the WX3310.
Click Networking > Wireless Network 5G/2.4G > Advanced . The screen appears as shown.
Figure 32 Networking > Wireless Network 5G/2.4G > Advanced
Channel
Selection Select the operating channel for the WX3310 and its wireless clients. The options vary depending
on the frequency band and the country you are in.
Select Auto and the WX3310 selects a channel automatically.
Select Smart Channel Selection ( SCS ), and the WX3310 decides to switch channels, monitors
several channels and chooses the one with higher capacity.
Current
Channel This displays the channel the WX3310 is currently using.
Encryption Select the data encryption method the WX3310 uses.
Select WPA2-AES or WPA2 + WPA (mixed mode) to add security on this wireless network. The
wireless clients which want to associate to this network must have same wireless security settings
as this device. Or you can select
No Security to allow any client to associate this network without
authentication.
Pre-Shared Key Enter the password that lets you connect to the WX3310. Your password should be in a string of
ASCII characters between 8 and 63 or hexadecimal characters between 8 and 64.
Group Key
Update Timer The Group Key Update Timer is the rate at which the WX3310 sends a new group key out to
clients.
Clone setting
from AP
connection Select this to copy the password and SSID from the wireless router or AP to the WX3310. Wireless
clients can then connect to the WX3310 using the same SSID and password as they did to
connect to the wireless router,
The check box is not available when the WX3310 is in AP mode.
Apply Click Apply to save your changes back to the WX3310.
Cancel Click Cancel to reload the previous configuration for this screen.
Table 16 Networking > Wireless Network 5G/2.4G > Basic (continued)
LABEL DESCRIPTION