ZyXEL Communications VMG5313-B10A, Руководство пользователя

Страница: 292 / 398

Chapter 23 Voice
VMG5313-B10A/-B30A Series User’s Guide
292
Note: To take full advantage of the supplementary phone services available through the
VMG's phone ports, you may need to subscribe to the services from your VoIP
service provider.
23.10.2.1 The Flash Key
Flashing means to press the hook for a short period of time (a few hundred milliseconds) before
releasing it. On newer telephones, there should be a "flash" key (button) that generates the signal
electronically. If the flash key is not available, you can tap (press and immediately release) the
hook by hand to achieve the same effect. However, using the flash key is preferred since the timing
is much more precise. With manual tapping, if the duration is too long, it may be interpreted as
hanging up by the VMG.
You can invoke all the supplementary services by using the flash key.
23.10.2.2 Europe Type Supplementary Phone Services
This section describes how to use supplementary phone services with the Europe Type Call
Service Mode . Commands for supplementary services are listed in the table below.
After pressing the flash key, if you do not issue the sub-command before the default sub-command
timeout (2 seconds) expires or issue an invalid sub-command, the current operation will be
aborted.
European Call Hold
Call hold allows you to put a call ( A ) on hold by pressing the flash key.
If you have another call, press the flash key and then “2” to switch back and forth between caller A
and B by putting either one on hold.
Press the flash key and then “0” to disconnect the call presently on hold and keep the current call
on line.
Press the flash key and then “1” to disconnect the current call and resume the call on hold.
If you hang up the phone but a caller is still on hold, there will be a remind ring.
Table 120
European Flash Key Commands
COMMAND SUB-COMMAND DESCRIPTION
Flash Put a current call on hold to place a second call.
Switch back to the call (if there is no second call).
Flash 0 Drop the call presently on hold or reject an incoming call which is waiting
for answer.
Flash 1 Disconnect the current phone connection and answer the incoming call or
resume with caller presently on hold.
Flash 2 1. Switch back and forth between two calls.
2. Put a current call on hold to answer an incoming call.
3. Separate the current three-way conference call into two individual calls
(one is on-line, the other is on hold).
Flash 3 Create three-way conference connection.
Flash *98# Transfer the call to another phone.