ZyXEL Communications VMG1312-T10C, Руководство пользователя

Страница: 114 / 238

Chapter 9 Quality of Service (QoS)
VMG1312-T10C User’s Guide
122
9.3.1 Edit a QoS Queue
Use this screen to configure a queue. Click the Edit icon next to a QoS queue.
Figure 81
Queue Setup: Edit
The following table describes the labels in this screen.
9.4 The Class Setup Screen
Use this screen to add, edit or delete QoS classifiers. A classifier groups traffic into data flows
according to specific criteria such as the source address, destination address, source port number,
destination port number or incoming interface. For example, you can configure a classifier to select
traffic from the same protocol port (such as Telnet) to form a flow.
You can give different priorities to traffic that the Device forwards out through the WAN interface.
Give high priority to voice and video to make them run more smoothly. Similarly, give low priority
to many large file downloads so that they do not reduce the quality of other applications.
Table 41
Queue Setup: Edit
LABEL DESCRIPTION
Active Select to enable or disable this queue.
Name Enter the descriptive name of this queue.
Interface Select the interface of this queue.
Priority Select the priority level (from 1 to 7) of this queue.
The lower the number, the higher the priority level. Traffic assigned to higher priority
queues gets through faster while traffic in lower priority queues is dropped if the
network is congested.
Weight Select the weight (from 1 to 15) of this queue.
If two queues have the same priority level, the Device divides the bandwidth across the
queues according to their weights. Queues with larger weights get more bandwidth
than queues with smaller weights.
Rate Limit Specify the maximum transmission rate (in Kbps or %) allowed for traffic on this queue.
OK Click this to save your changes.
Cancel Click this to exit this screen without saving.