ZyXEL Communications USG110, Руководство пользователя

Страница: 833 / 1090

Chapter 43 Object
ZyWALL USG Series User’s Guide
833
43.5.1 ZyMesh Profile
This screen allows you to manage and create ZyMesh profiles that can be used by the APs. To access
this screen, click
Configuration > Object > ZyMesh Profile .
Figure 573 Configuration > Object > ZyMesh Profile
The following table describes the labels in this screen.
Table 314 Configuration > Object > ZyMesh Profile
LABEL DESCRIPTION
Hide / Show
Advanced
Settings Click this to display a greater or lesser number of configuration fields.
ZyMesh Provision
Group By default, this shows the MAC address used by the Zyxel Device’s first Ethernet port.
Say you have two AP controllers (Zyxel Devices) in your network and the primary AP controller is
not reachable. You may want to deploy the second/backup AP controller in your network to
replace the primary AP controller. In this case, it is recommended that you enter the primary AP
controller’s
ZyMesh Provision Group MAC address in the second AP controller’s ZyMesh
Provision Group field.
If you didn’t change the second AP controller’s MAC address, managed APs in an existing
ZyMesh can still access the networks through the second AP controller and communicate with
each other. But new managed APs will not be able to communicate with the managed APs in
the existing ZyMesh, which is set up with the primary AP controller’s MAC address.
To allow all managed APs to communicate in the same ZyMesh, you can just set the second AP
controller to use the primary AP controller’s MAC address. Otherwise, reset all managed APs to
the factory defaults and set up a new ZyMesh with the second AP controller’s MAC address.
Next Click this button and follow the on-screen instructions to update the AP controller’s MAC
address.
Add Click this to add a new profile.
Edit Click this to edit the selected profile.
Remove Click this to remove the selected profile.
# This field is a sequential value, and it is not associated with a specific profile.