ZyXEL Communications UAG2100, Руководство пользователя

Страница: 520 / 617

Chapter 46 System
UAG Series User’s Guide
520
3
Authentication and Data Transmission
After the identification is verified and data encryption activated, a secure tunnel is established
between the client and the server. The client then sends its authentication information (user name
and password) to the server to log in to the server.
46.8.2 SSH Implementation on the UAG
Your UAG supports SSH versions 1 and 2 using RSA authentication and four encryption methods
(AES, 3DES, Archfour, and Blowfish). The SSH server is implemented on the UAG for management
using port 22 (by default).
46.8.3 Requirements for Using SSH
You must install an SSH client program on a client computer (Windows or Linux operating system)
that is used to connect to the UAG over SSH.
46.8.4 Configuring SSH
Click Configuration > System > SSH to change your UAG’s Secure Shell settings. Use this screen
to specify from which zones SSH can be used to manage the UAG. You can also specify from which
IP addresses the access can come.
Figure 362
Configuration > System > SSH
The following table describes the labels in this screen.
Table 244
Configuration > System > SSH
LABEL DESCRIPTION
Enable Select the check box to allow or disallow the computer with the IP address that matches
the IP address(es) in the
Service Control table to access the UAG CLI using this service.
Version 1 Select the check box to have the UAG use both SSH version 1 and version 2 protocols. If
you clear the check box, the UAG uses only SSH version 2 protocol.