ZyXEL Communications Prestige 642M series, Руководство пользователя

Страница: 56 / 86

Prestige 642M Series ADSL Bridge
6-6 System Maintenance
Table 6-3 System Maintenance Menu Diagnostic
Field
Description
Reset ADSL This command re-initializes the ADSL link to the telephone company.
Ping Host This diagnostic test pings the host, which determines the functionality of the
TCP/IP protocol on both systems and the links in between.
Reboot System This option reboots the Prestige.
Command Mode This option allows you to enter the command mode. This mode allows you
to diagnose and test your Prestige using a specified set of commands.
6.4 A Note about Filenames
The configuration file (often called the romfile or romfile-0) contains the factory default settings in the
menus such as password, DHCP Setup, TCP/IP Setup etc. It arrives from ZyXEL with a name of
P642M.rom or something similar. Once you have customized the Prestige's setting, they can be saved back
to your computer under a filename of your choosing. Choose something meaningful, e.g. “MyP642M.cfg”.
The ZyNOS firmware file (sometimes referred to as the ras file) is the file that contains the ZyXEL
Network Operating System firmware and usually is the router model name with a *.bin extension, e.g.,
P642M.bin.
With serial (Xmodem) transfer and many ftp and tftp clients (see next), the filenames on the PC are your
choice.
ftp>
put P642M.bin ras
This is a sample ftp session showing the transfer of the your computer "P642M.bin" to the Prestige.
ftp>
get rom-0 MyP642M.cfg
This is a sample ftp session saving the current configuration to the file MyP642M.cfg on your computer.
If your [t]ftp client does not allow you to have a destination filename different from the source, you will
need to rename them, as the Prestige only recognizes "rom-0" and "ras". Be sure you keep unaltered copies
of both files for later use.
The following table is a summary. Please note that the internal filename refers to the filename on the
Prestige and the external filename refers to the filename not on the Prestige, i.e., on your workstation, local
network or ftp site and so the name (but not the extension) will vary. The AT command is the command
you enter after you press “Y” when prompted in the SMT menu to go into debug mode.