Chapter 2 Hardware
PM7300-T0 User’s Guide
12
2.1.2 Panel Ports & Buttons
Figure 3
Side Panel
The following table describes the items on the rear panel.
2.1.3 RESET Button
Insert a thin object into the
RESET
hole of the PM7300-T0 to reload the factory-default configuration file if
you forget your password or IP address, or you cannot access the Web Configurator. This means that
you will lose all configurations that you had previously saved. The password will be reset to
the default
(see the PM7300-T0 label)
and the IP address will be reset to
192.168.0.1
.
PON
Green
On
The PON connection is ready.
Blinking
The PM7300-T0 is trying to establish a link.
Off
The fiber link is down.
LOS
Red
On
PON transceiver is powered down.
Blinking
This is a R(x) low power alarm.
Off
The PON connection is working normally.
10GbE
Green
On
The Ethernet link is up.
Blinking
The PM7300-T0 is transmitting or receiving data.
Off
The Ethernet link is down.
Table 2 PM7300-T0 LED Behavior (continued)
LED
COLOR
STATUS
DESCRIPTION
Table 3 Panel Ports and Buttons
LABELS
DESCRIPTION
RESET
Press for 5 seconds to restore the PM7300-T0 to its factory default settings.
PON
Connect the PM7300-T0 to the Internet using a fiber cable.
10GbE
Connect the PM7300-T0 to an Ethernet device such as a network switch, NAS or server. Connect a
computer for initial configuration.
POWER
Connect the power adapter and press the
POWER
button to start the PM7300-T0.
ON/OFF
Press the
ON/OFF
button after connecting the power adapter to start the PM7300-T0.
