Chapter 1 Introduction
PM7516-R0 / PM7116-R0 User’s Guide
12
1.4.4 Reset Button
If you forget your password or cannot access the Web Configurator, you will need to use the
RESET
button on the rear panel of the device to reload the factory system configuration. This means that you
will lose all configurations that you had previously and the password will be reset to the default.
1
Make sure the
POWER
LED is on (not blinking).
2
Press the
RESET
button for more than 5 seconds or until the
POWER
LED begins to blink. Wait for the
POWER
LED to turn solid green. At this point, the device is reset to factory default settings.
Figure 6
Reset Button (PM7516-R0)
4
GND
5
GND
6
UPS status: Replace battery
7
UPS status: Low battery
8
NA
Table 4 UPS Port Pin Assignment (continued)
PIN UPS PORT
Содержание PM7116-R0
Страница 7: ...7 PART I User s Guide...
Страница 17: ...17 PART II Technical Reference...
Страница 40: ...40 PART III Appendices Appendices contain general information Some information may not apply to your device...
Страница 42: ...Appendix A Wall Mounting PM7516 R0 PM7116 R0 User s Guide 42 Figure 27 Drill Holes 60 0 mm Apart...
