ZyXEL Communications PLA-450 - V3.60, Руководство пользователя

Страница: 118 / 190

Chapter 14 Troubleshooting
PLA450 User’s Guide
118
2 If you are trying to access the Internet wirelessly, make sure the wireless settings in the
wireless client are the same as the settings in the PLA450.
3 Disconnect all the cables from your device, and follow the directions in the Quick Start
Guide again.
4 If the problem continues, contact your ISP.
V
I cannot access the Internet anymore. I had access to the Internet (with the
PLA450), but my Internet connection is not available anymore.
1 Check the hardware connections, and make sure the LEDs are behaving as expected. See
the Quick Start Guide and
Section 1.4 on page 25 .
2 Reboot the PLA450.
3
If the problem continues, contact your ISP.
V
The Internet connection is slow or intermittent.
1
There might be a lot of traffic on the network. Look at the LEDs, and check Section 1.4
on page 25 . If the PLA450 is sending or receiving a lot of information, try closing some
programs that use the Internet, especially peer-to-peer applications.
2 Check the signal strength. If the signal strength is low, try moving the PLA450 closer to
the AP if possible, and look around to see if there are any devices that might be
interfering with the wireless network (for example, microwaves, other wireless
networks, and so on).
3 Reboot the PLA450.
4
If the problem continues, contact the network administrator or vendor, or try one of the
advanced suggestions.
Advanced Suggestions
• Check the settings for QoS. If it is disabled, you might consider activating it. If it is
enabled, you might consider raising or lowering the priority for some applications.
14.4 Resetting the PLA450 to Its Factory Defaults
If you reset the PLA450, you lose all of the changes you have made. The PLA450 re-loads its
default settings, and the password resets to
1234 . You have to make all of your changes again.
V
You will lose all of your changes when you push the RESET button.
To reset the PLA450,