ZyXEL Communications PLA-402 v3, Руководство пользователя

Страница: 24 / 94

Chapter 2 Installing the Utility
PLA-402 v3 User’s Guide
24
5
When the installation is finished, a screen appears to confirm that the PLA-4xx
Series Configuration Utility has been successfully installed on your computer.
Click Close to exit the wizard.
Figure 8 Installation Complete
Note: You may be asked to restart your computer when the installation is complete.
Click “Yes” to restart your computer. If you select “No, I will restart my computer
later”, you will not be able to launch the utility until after a restart of your
computer.
2.3 Low Power Mode
Your PLA-402 v3 is a certified green product. It goes into Low Power mode when
there is no Ethernet connection.
When you plug the PLA-402 v3 into an electric socket, it waits for an Ethernet
connection. When no connection is detected after 120 seconds, the
Power LED
blinks indicating that it is going into Low Power mode.
The same process occurs when you disconnect the PLA-402 v3 from a previously
working Ethernet connection. 120 seconds after disconnecting the Ethernet cable,
the PLA-402 v3’s
Power LED blinks signalling that it is going into Low Power
mode.
The Ethernet and HomePlug LEDs are turned off in Low Power mode.
While in Low Power mode, you cannot use the SETUP button. To enable the
SETUP button again, you have to connect the PLA-402 v3’s Ethernet cable to a
computer/notebook or modem/router first. The PLA-402 v3 wakes up from Low
Power mode and you can start using the
SETUP button.
Low Power mode is enabled by default.