ZyXEL Communications P-861H-G1, Руководство пользователя, Страница: 43 / 341

Prestige 861H Series User’s Guide
Chapter 1 Getting To Know Your Prestige 42
1.1.4 Rear Panel
Figure 5 P-861H Rear Panel
1.1.4.1 VDSL Port
Connect the Prestige directly to the wall jack using a telephone wire (RJ-11 connector).
1.1.4.2 Ground (Available on some models)
Connect a grounding cable to the ground connector to protect your device from electrical
surges.
1.1.4.3 LAN 1 ~ 4
The Prestige has four 10/100Mbps auto-negotiating, auto-crossover Ethernet ports. The LAN
interface is auto-crossover, so you may use a crossover cable or a straight-through Ethernet
cable to connect your Prestige to a computer/external hub.
1.1.4.4 Console Port
You can configure the Prestige via a terminal emulator software on a computer that is
connected to the Prestige through the console port. Connect the male end of the console cable
to the console port of the Prestige and the female end to a serial port (COM1, COM2 or other
COM port) of your computer.
1.1.4.5 Reset Button
If you forget your password or cannot access the web configurator, you will need to use the
RESET button at the back of the Prestige to reload the factory-default configuration file. This
means that you will lose all configurations that you had previously and the password will be
reset to “1234”.
1.1.4.5.1 Using the Reset Button
1
Make sure the SYS LED is on (not blinking).
2 Press the RESET button for five seconds or until the SYS LED begins to blink and then
release it. When the SYS LED begins to blink, the defaults have been restored and the
Prestige restarts.