Chapter 7 WAN Setup
P-660W-Tx v2 User’s Guide
84
The following table describes the fields in this screen.
Table 26
WAN Setup
LABEL
DESCRIPTION
Name
Enter the name of your Internet Service Provider, e.g., MyISP. This information
is for identification purposes only.
Mode
Select
Routing
(default) from the drop-down list box if your ISP allows multiple
computers to share an Internet account. Otherwise select
Bridge
.
Encapsulation
Select the method of encapsulation used by your ISP from the drop-down list
box. Choices vary depending on the mode you select in the
Mode
field.
If you select
Bridge
in the
Mode
field, select either
PPPoA
or
RFC 1483
.
If you select
Routing
in the
Mode
field, select
PPPoA
,
RFC 1483
,
ENET
ENCAP
or
PPPoE
.
Multiplex
Select the method of multiplexing used by your ISP from the drop-down list.
Choices are
VC
or
LLC
.
Virtual Circuit ID
VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a virtual
circuit. Refer to the appendix for more information.
VPI
The valid range for the VPI is 0 to 255. Enter the VPI assigned to you.
VCI
The valid range for the VCI is 32 to 65535 (0 to 31 is reserved for local
management of ATM traffic). Enter the VCI assigned to you.
ATM QoS Type
Select
CBR
(Continuous Bit Rate) to specify fixed (always-on) bandwidth for
voice or data traffic. Select
UBR
(Unspecified Bit Rate) for applications that are
non-time sensitive, such as e-mail. Select
VBR
(Variable Bit Rate) for bursty
traffic and bandwidth sharing with other applications.
Cell Rate
Cell rate configuration often helps eliminate traffic congestion that slows
transmission of real time data such as audio and video connections.
Peak Cell Rate
Divide the DSL line rate (bps) by 424 (the size of an ATM cell) to find the Peak
Cell Rate (PCR). This is the maximum rate at which the sender can send cells.
Type the PCR here.
Sustain Cell Rate
The Sustain Cell Rate (SCR) sets the average cell rate (long-term) that can be
transmitted. Type the SCR, which must be less than the PCR. Note that system
default is 0 cells/sec.
Maximum Burst
Size
Maximum Burst Size (MBS) refers to the maximum number of cells that can be
sent at the peak rate. Type the MBS, which is less than 65535.
Login Information
(PPPoA and PPPoE encapsulation only)
Service Name
(PPPoE only) Type the name of your PPPoE service here.
User Name
Enter the user name exactly as your ISP assigned. If assigned a name in the
form user@domain
where domain identifies a service name, then enter both
components exactly as given.
Password
Enter the password associated with the user name above.
IP Address
This option is available if you select
Routing
in the
Mode
field.
A static IP address is a fixed IP that your ISP gives you. A dynamic IP address is
not fixed; the ISP assigns you a different one each time you connect to the
Internet.
Select
Obtain an IP Address Automatically
if you have a dynamic IP address;
otherwise select
Static IP Address
and type your ISP assigned IP address in
the
IP Address
field below.
Содержание P-660W-T1 v2
