ZyXEL Communications P-660RU-T1 v3, Руководство пользователя, Страница: 99 / 230

P-660RU-Tx v3 User’s Guide
99
C
H A P T E R
11
Quality of Service (QoS)
11.1 Overview
Use the QoS screen to set up your ZyXEL Device to use QoS for traffic management.
Quality of Service (QoS) refers to both a network’s ability to deliver data with minimum
delay, and the networking methods used to control bandwidth. QoS allows the ZyXEL Device
to group and prioritize application traffic and fine-tune network performance.
Without QoS, all traffic data are equally likely to be dropped when the network is congested.
This can cause a reduction in network performance and make the network inadequate for time-
critical applications such as video-on-demand.
The ZyXEL Device assigns each packet a priority and then queues the packet accordingly.
Packets assigned with a high priority are processed more quickly than those with low priorities
if there is congestion, allowing time-sensitive applications to flow more smoothly. Time-
sensitive applications include both those that require a low level of latency (delay) and a low
level of jitter (variations in delay) such as Voice over IP (VoIP) or Internet gaming, and those
for which jitter alone is a problem such as Internet radio or streaming video.
In the following figure, your Internet connection has an upstream transmission speed of 50
Mbps. You configure a classifier to assign the highest priority queue (6) to VoIP traffic from
the LAN interface, so that voice traffic would not get delayed when there is network
congestion. Traffic from the boss’s IP address (192.168.1.23 for example) is mapped to queue
5. Traffic that does not match these two classes are assigned priority queue based on the
internal QoS mapping table on the ZyXEL Device.
Figure 40 QoS Example
50 Mbps
DSL
VoIP: Queue 6
Boss: Queue 5
IP=192.168.1.23