ZyXEL Communications P-660RU-T1 v3, Руководство пользователя, Страница: 93 / 230

Chapter 10 Network Address Translation (NAT)
P-660RU-Tx v3 User’s Guide
93
10.5 The IP Address Mapping Screen
Configure this screen if you have multiple IP addresses from your ISP and you want to map
them to private IP addresses on your LAN.
"
The Address Mapping screen is available only when you select Multiple for
the Number of IPs in the NAT screen.
Ordering your rules is important because the ZyXEL Device applies the rules in the order that
you specify. When a rule matches the current packet, the ZyXEL Device takes the
corresponding action and the remaining rules are ignored.
Start Port
Number
Enter a port number in this field.
To forward only one port, enter the port number again in the
End Port Number
field.
To forward a series of ports, enter the start port number here and the end port
number in the End Port Number field.
End Port Number Enter a port number in this field.
To forward only one port, enter the port number again in the
Start Port Number
field above and then enter it again in this field.
To forward a series of ports, enter the last port number in a series that begins with
the port number in the Start Port Number field above.
Local IP Address Enter the inside IP address of the server in this field.
Virtual Server Listing
Rule This is the rule’s index number.
Application This is a service’s name.
Protocol This is the IP port.
Start Port This is the first port number that identifies a service.
End Port This is the last port number that identifies a service.
Local IP Address This is the server’s IP address.
SAVE Click this to save your changes.
DELETE Click this to remove the rule.
BACK Click this to return to the previous screen without saving.
CANCEL Click this to restore your previously saved settings.
Table 24 Advanced Setup > NAT > Virtual Server
LABEL DESCRIPTION