ZyXEL Communications P-660HWP-D1, Руководство пользователя

Страница: 238 / 374

Chapter 17 Remote Management Configuration
P-660HWP-D1 User’s Guide
238
The following table describes the labels in this screen.
17.7 Configuring DNS
Use DNS (Domain Name System) to map a domain name to its corresponding IP address and
vice versa. Refer to the chapter on LAN for background information.
To change your P-660HWP-D1’s DNS settings, click
Advanced > Remote MGMT > DNS .
The screen appears as shown. Use this screen to set from which IP address the P-660HWP-D1
will accept DNS queries and on which interface it can send them your P-660HWP-D1’s DNS
settings.
Table 102 Remote Management: SNMP
LABEL DESCRIPTION
SNMP
Port You may change the server port number for a service if needed, however you
must use the same port number in order to use that service for remote
management.
Access Status Select the interface(s) through which a computer may access the P-660HWP-
D1 using this service.
Secured Client IP A secured client is a “trusted” computer that is allowed to communicate with the
P-660HWP-D1 using this service.
Select
All to allow any computer to access the P-660HWP-D1 using this
service.
Choose
Selected to just allow the computer with the IP address that you specify
to access the P-660HWP-D1 using this service.
SNMP Configuration
Get Community Enter the Get Community , which is the password for the incoming Get and
GetNext requests from the management station. The default is public and
allows all requests.
Set Community Enter the Set community , which is the password for incoming Set requests
from the management station. The default is public and allows all requests.
TrapCommunity Type the trap community, which is the password sent with each trap to the
SNMP manager. The default is public and allows all requests.
TrapDestination Type the IP address of the station to send your SNMP traps to.
Apply Click Apply to save your customized settings and exit this screen.
Cancel Click Cancel to begin configuring this screen afresh.