ZyXEL Communications P-660H-T1 v3s, Руководство пользователя

Страница: 24 / 272

Chapter 1 Introduction
P-660H-T1v3s User’s Guide
24
The following table describes the labels in this picture.
Refer to the Quick Start Guide for information on hardware connections.
1.5 The RESET Button
If you forget your password or cannot access the web configurator, you will need
to use the RESET button at the back of the device to reload the factory-default
configuration file. This means that you will lose all configurations that you had
previously and the password will be reset to “1234”. You can also use the
Table 1 LED Descriptions
LED COLOR STATUS DESCRIPTION
POWER Green On The P-660H-T1v3s is receiving power and ready
for use.
Red On The P-660H-T1v3s detected an error while self-
testing, or there is a device malfunction.
Off The P-660H-T1v3s is not receiving power.
ETHERNET
1-4 Green On The P-660H-T1v3s has an Ethernet connection
with a device on the Local Area Network (LAN).
Blinking The P-660H-T1v3s is sending/receiving data,
Off The P-660H-T1v3s does not have an Ethernet
connection with the LAN.
DSL Green On The DSL line is up.
Blinking The P-660H-T1v3s is initializing the DSL line.
Off The DSL line is down.
INTERNET Green On The P-660H-T1v3s has an IP connection but no
traffic.
Your device has a WAN IP address (either static
or assigned by a DHCP server), PPP negotiation
was successfully completed (if used) and the
DSL connection is up.
Blinking The P-660H-T1v3s is sending or receiving IP
traffic.
Red On The P-660H-T1v3s attempted to make an IP
connection but failed. Possible causes are no
response from a DHCP server, no PPPoE
response, PPPoE authentication failed.
Off The P-660H-T1v3s does not have an IP
connection.