ZyXEL Communications OMC-2301, Руководство пользователя

Страница: 148 / 224

Chapter 19 Introducing the Commands
OMC-2301 User’s Guide
148
19.3 The Login Screen
After you have successfully established a connection to the OMC using a direct console
connection or Telnet. The following figure shows a login screen example. For your first login,
enter the default administrator login username
admin and password 1234 .
19.4 Command Syntax Conventions
The rules of the commands are listed next.
• The command keywords are in
courier new
font.
• The required fields in a command are enclosed in angle brackets
<>
, for instance,
ping
<ip>
means that you must specify an IP number for this command.
• The optional fields in a command are enclosed in square brackets
[]
, for instance,
configure snmp-server [contact <system contact>] [location <system location>]
means that the
contact
and
location
fields are optional.
• “Command” refers to a command used.
• The
|
symbol means “or”.
• The entry
<cr>
in the command lines refers to carriage return. Press
[ENTER]
or carriage
return after a command to execute the command.
• Use the up (
y
) or down (
z
) arrow key to scroll through the command history list.
• The CLI does not accept partial or incomplete commands. You may enter a unique part of
a command and press [TAB] to have the OMC automatically display the full command.
For example, if you enter “
config
” and press [TAB], the full command of “
configure
”
automatically displays.
• Type multiple ports or port ranges separated by a comma. Ranges of port numbers are
typed separated by a dash.
19.5 Changing the Password
This command is used to change the password for Enable mode. By default the same password
is used to enter the command line interface (CLI) and Enable and Config modes of the CLI.
The password you change with this command is required to enter Enable and Config modes of
the CLI.
Syntax:
password <password>
Enter User Name : admin
Enter Password : XXXX