ZyXEL Communications NWA1123-ACv2, Руководство пользователя

Страница: 133 / 218

Chapter 12 System
NWA1123-ACv2 User’s Guide
133
3
The CLI screen displays next.
12.6 Telnet
You can use Telnet to access the NWA’s command line interface. Click Configuration > System >
TELNET to configure your NWA for remote Telnet access. Use this screen to enable or disable Telnet
and set the server port number.
Figure 84
Configuration > System > TELNET
The following table describes the labels in this screen.
12.7 FTP
You can upload and download the NWA’s firmware and configuration files using FTP. To use this
feature, your computer must have an FTP client. See
Chapter 14 on page 152 for more information
about firmware and configuration files.
To change your NWA’s FTP settings, click Configuration > System > FTP tab. The screen appears
as shown. Use this screen to specify FTP settings.
Table 60
Configuration > System > TELNET
LABEL DESCRIPTION
Enable Select the check box to allow or disallow the computer with the IP address that matches
the IP address(es) in the
Service Control table to access the NWA CLI using this service.
Server Port You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Apply Click Apply to save your changes back to the NWA.
Reset Click Reset to return the screen to its last-saved settings.