ZyXEL Communications MSC1000G Series, Руководство пользователя

Страница: 992 / 1168

Chapter 33 switch Commands
Management Switch Card User’s Guide
992
where
This command turns on bandwidth control on the specified port(s).
This example turns on bandwidth control for the subtending 2 port.
33.4.3 switch bandwidth set Command
Syntax:
switch bandwidth set <giga-port> <ingress-rate> <egress-rate>
where
This command sets the incoming or outgoing bandwidth control for the specified port(s).
This example sets the subtending 2 port to only allow 128 Mbps for incoming traffic and 512 Mbps
for outgoing traffic.
33.4.4 switch bandwidth show Command
Syntax:
switch bandwidth show
This command displays the bandwidth control settings on the Gigabit Ethernet interfaces.
This example displays the bandwidth control settings on the Ethernet ports.
< giga-port >
= This represents Gigabit Ethernet uplink ports, subtending ports or all ports. Use
sub1|sub2|up1|up2|all i
f trunking is not enabled. Use
t
sub|tup|all
if trunking is enabled.
ras> switch bandwidth enable sub2
<
giga-port
>
=
This represents Gigabit Ethernet uplink ports, subtending ports or all ports.
Use
sub1|sub2|up1|up2|all i
f trunking is not enabled. Use
sub|up|all
if trunking is enabled.
<
ingress-rate
> = The maximum bandwidth allowed in megabits per second (Mbps) for the
incoming traffic flow on a port. Use a number between 1 and 1000.
<
egress-rate
>
=
The maximum bandwidth allowed in megabits per second (Mbps) for the
out-going traffic flow on a port. Use a number between 1 and 1000.
ras> switch bandwidth set sub2 128 512
ras> switch bandwidth show
port enable ingress(Mbps) egress(Mbps)
----- ------ ------------- -------------
sub1 - 0 0
sub2 - 0 0
up1 - 0 0
up2 - 0 0
'0' = disable