ZyXEL Communications MSC1000G Series, Руководство пользователя

Страница: 791 / 1168

Chapter 29 port Commands
Management Switch Card User’s Guide
791
29.10.13 port enet ratelimit Command
Syntax:
port enet ratelimit < slot-port > < rate-limit_profile >
This command sets the specified Ethernet port(s) to use a profile that limits egress and ingress
rates.
The following example sets port 13 on the ELC in slot 7 to use a rate limit profile named test.
29.10.14 port enet show Command
Syntax:
port enet show < slot-port >
This command displays the settings for the specified Ethernet subscriber port(s). An example is
shown next for port 5 on the ELC in slot 4.
29.10.15 port enet tls Commands
Syntax:
port enet tls disable < slot-port >
port enet tls enable < slot-port >
port enet tls set < slot-port > < svid > < spriority >
port enet tls show < slot-port >
where
Use these commands to configure Transparent LAN Service (TLS) settings on the Ethernet
subscriber port(s). Once you enable TLS, all packets will be added an extra “VLAN tag” (SPVID/
ras> port enet ratelimit 7-13 test
ras> port enet show 4-5
slot-port :4-5
pvid :76
priority :3
frametype :all
flowCtrl :disable
ingress rate :0 kbps
egress rate :0 kbps
vlan setting:
vid port adv untag
----- ----- -------- --------
76 4-5 fix untag
< svid >
=
Sets the service provider ID (from 1 to 4094) to add to received frames.
< spriority >
=
Sets the IEEE 802.1p priority level (from 0 to 7) for the service provider’s VLAN
ID.