ZyXEL Communications MSC1000G Series, Руководство пользователя

Страница: 535 / 1168

Chapter 13 Switch Screens
Management Switch Card User’s Guide
535
13.15 Switch Port Setup 802.1P/1Q Screen
Click Switch > Switch Port Setup > 802.1P/1Q in the navigation panel to display the screen
shown next. Use this screen to configure IEEE 802.1p priority and IEEE 802.1Q VLAN settings for
the Gigabit Ethernet interfaces.
Figure 368
Switch Port Setup: 802.1P/1Q
The following table describes the labels in this screen.
Table 282
Switch Port Setup: 802.1P/1Q
LABEL DESCRIPTION
Port This is the label of a Gigabit Ethernet interface.
Default Priority Select a default priority to use for frames that come into the interface without a IEEE
802.1p priority tag.
Default VLAN ID
[1-4094] Select a default VLAN ID to use for frames that come into the interface without a IEEE
802.1Q VLAN ID.
GVRP Select this check box to turn on GARP VLAN Registration Protocol to have the interface
propagate VLAN information to other devices.
Clear the check box to not have the interface propagate VLAN information to other
devices.
Frame Type Select all to have the interface accept all Ethernet frames. Select tag to have the
interface only accept frames with an IEEE 802.1Q VLAN tag.
VLAN Trunk Select this check box to have the interface use VLAN trunking in order to accept frames
with any VID.
Clear the check box to have the interface only accept frames with registered VIDs.
Apply Click Apply to save the changes in this screen to the system’s volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save link
on the navigation panel and then the Save button to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.