Chapter 22 Policy Rule
MGS3520 Series User’s Guide
187
22.3 Viewing and Editing Policy Configuration
To view a summary of the classifier configuration, scroll down to the summary table at the bottom
of the
Policy
screen. To change the settings of a rule, click a number in the
Index
field.
Figure 106
Advanced Application > Policy Rule: Summary Table
General
Egress Port
Type the number of an outgoing port.
Priority
Specify a priority level.
DSCP
Specify a DSCP (DiffServ Code Point) number between 0 and 63.
TOS
Specify the type of service (TOS) priority level.
Rate Limit
You can configure the desired bandwidth available to a traffic flow.
Bandwidth
Specify the bandwidth in kilobit per second (Kbps). Enter a number between 1 and 1000000.
Action
Specify the action(s) the Switch takes on the associated classified traffic flow.
Forwarding
Select
No change
to forward the packets.
Select
Discard the packet
to drop the packets.
Select
Do not drop the matching frame previously marked for dropping
to retain the
frames that were marked to be dropped before.
Priority
Select
No change
to keep the priority setting of the frames.
Select
Set the packet’s 802.1p priority and send the packet to priority queue
to
replace the packet’s 802.1p priority field with the value you set in the Priority field. Then put
the packets in the designated queue.
Diffserv
Select
No change
to keep the TOS and/or DSCP fields in the packets.
Select
Set the packet’s TOS field
to set the TOS field with the value you configure in the
TOS
field.
Select
Set the Diffserv Codepoint field in the frame
to set the DSCP field with the value
you configure in the
DSCP
field.
Outgoing
Select
Send the packet to the egress port
to send the packet to the egress port.
Rate Limit
Select
Enable
to activate bandwidth limitation on the traffic flow(s).
Add
Click
Add
to insert the entry in the summary table below and save your changes to the
Switch’s run-time memory. The Switch loses these changes if it is turned off or loses power,
so use the
Save
link on the top navigation panel to save your changes to the non-volatile
memory when you are done configuring.
Cancel
Click
Cancel
to begin configuring this screen afresh.
Clear
Click
Clear
to set the above fields back to the factory defaults.
Table 73
Advanced Application > Policy Rule (continued)
LABEL
DESCRIPTION
Содержание MGS3520 Series
