XMG1930 Series User’s Guide
280
C
HAPTER
34
Static Route
34.1 Static Routing Overview
This chapter shows you how to configure static routes.
The Switch usually uses the default gateway to route outbound traffic from computers on the LAN to the
Internet. To have the Switch send data to devices not reachable through the default gateway, use
static routes.
For example, the next figure shows a computer (
A
) connected to the Switch. The Switch routes most
traffic from
A
to the Internet through the Switch’s default gateway (
R1
). You create one static route to
connect to services offered by your ISP behind router
R2
. You create another static route to
communicate with a separate network behind a router
R3
connected to the Switch.
Figure 192
Example of Static Routing Topology
34.1.1 What You Can Do
• Use the
Static Routing
screen (
) to display the link to the
IPv4 Static Route
screen.
• Use the
IPv4 Static Route
) to configure and enable an IPv4 static
route.
• Use the
IPv6 Static Route
) to configure and enable an IPv6 static
route.
N1
Содержание MG1930-30
