ZyXEL Communications LTE6100, Руководство пользователя

Страница: 52 / 189

Chapter 7 Quality of Service (QoS)
LTE6100 User’s Guide
52
7.3.1 Add/Edit a QoS Queue
Use this screen to configure a queue. Click Add new Queue in the Queue Setup screen or the
Edit icon next to an existing queue.
Figure 26
Queue Setup: Add/Edit
The following table describes the labels in this screen.
7.4 The Class Setup Screen
Use this screen to add, edit or delete QoS classifiers. A classifier groups traffic into data flows
according to specific criteria such as the source address, destination address, source port number,
destination port number or incoming interface. For example, you can configure a classifier to select
traffic from the same protocol port (such as Telnet) to form a flow.
You can give different priorities to traffic that the LTE Device forwards out through the WAN
interface. Give high priority to voice and video to make them run more smoothly. Similarly, give low
priority to many large file downloads so that they do not reduce the quality of other applications.
Table 17
Queue Setup: Add/Edit
LABEL DESCRIPTION
Active Select to enable or disable this queue.
Name Enter the descriptive name of this queue.
Interface This shows the interface of this queue.
Priority Select the priority level (from 1 to 7) of this queue.
The larger the number, the higher the priority level. Traffic assigned to higher priority queues
gets through faster while traffic in lower priority queues is dropped if the network is
congested.
Weight Select the weight (from 1 to 15) of this queue.
If two queues have the same priority level, the LTE Device divides the bandwidth across the
queues according to their weights. Queues with larger weights get more bandwidth than
queues with smaller weights.
Rate Limit Specify the maximum transmission rate (in Kbps) allowed for traffic on this queue.
Apply Click Apply to save your changes.
Back Click Back to return to the previous screen without saving.