Chapter 6 WAN
LTE5366 Series User’s Guide
64
The following table describes the labels in this screen.
6.7 PIN Management
Use this screen to enable PIN authentication and configure the PIN code. Click
Configuration >
Network
>
WAN > PIN Management
from the
Configuration
menu.
Figure 36
Configuration > Network > WAN > PIN Management
Table 18 Configuration > Network > WAN > IPv6
LABEL
DESCRIPTION
IPv6
Select
Enable
to allow the LTE5366 to run IPv6. Otherwise, select
Disable
.
IPv6 Connection
Select
DHCPv6
if you want to obtain an IPv6 address from a DHCPv6 server.
DNS Setting
Select
Obtain DNS Server address Automatically
to have the LTE5366 get the IPv6 DNS
server addresses from the ISP automatically.
Select
Use the following DNS address
to have the LTE5366 use the IPv6 DNS server
addresses you configure manually.
Primary DNS Address
Enter the first IPv6 DNS server address assigned by the ISP.
Secondary DNS
Address
Enter the second IPv6 DNS server address assigned by the ISP.
LAN IPv6 Address
Enter the IPv6 address for the LTE5366 LAN interface in this field.
LAN IPv6 Link-Local
Address
This shows the IPv6 Link-local address in the LAN side. This is used by LTE5366 when
communicating with neighboring devices on the same link. It allows IPv6-capable
devices to communicate with each other in the LAN side.
Autoconfiguration
Click
Enable
if you want the devices on your local area network to obtain network
address that are not managed by a DHCPv6 server. Otherwise, select
Disable
.
Autoconfiguration Type Select
Stateless
if you want the LTE5366 interface to automatically generate a link-local
address via stateless auto configuration.
Select
Stateful (DHCPv6)
when the devices connected to your LAN needs to have their
TCP/IP configuration set to DHCPv6 or obtain an IPv6 address automatically.
IPv6 Address
Range(Start)
If you select
Stateful (DHCPv6)
, specify the range of IPv6 addresses from which the
DHCPv6 server assigns to the clients. Enter the smallest value of the last block of the IPv6
addresses which are to be allocated.
IPv6 Address
Range(End)
If you select
Stateful (DHCPv6)
, specify the range of IPv6 addresses from which the
DHCPv6 server assigns to the clients. Enter the largest value of the last block of the IPv6
addresses which are to be allocated.
Cancel
Click
Cancel
to reload the previous configuration for this screen.
Apply
Click
Apply
to save your changes back to the LTE5366.
Содержание LTE5366 Series
